Step 10 – Unbolt the clutch slave cylinder from the transmission

Tools Needed: 10mm Socket Wrench and 12mm Socket Wrench

Unscrew the two 10mm bolts holding the clutch slave cylinder bracket on the transmission and then move the bracket out of the way and screw the 2 bolts back into the transmission. Then use a 12mm wrench and unbolt the 2 slave cylinder bolts and once again move the slave cylinder out of the way and screw the bolts back into there original place on the tranny.

Step 11 – Drain the transmission oil

Tools Needed: 4″ Deep Drain Pan, 3/8″ Drive Racket

Place a 4″ drain pan under the transmission and use a 3/8″ drive racket to unscrew the transmission drain plug. Wait till all the oil has drained out then put the plug back in and tighten with your hand.

.

Click Here for Step 12 and 13

If you enjoyed this post, make sure you subscribe to my RSS feed!