Step 21 - Support the tranny with an extra floor jack and then unbolt it. Tools Needed: 17mm Deep Socket Wrench, Floor Jack, 2×4 Piece of wood. Place a 2nd jack with a piece of 2×4 wood under the tranny. Then get your friend to grab a hold of the rope with some gloves. Once the tranny is supported you [...]
Step 18 – Support engine with a floor jack and piece of 2×4 wood Tools Needed: Floor Jack and a 8-12″ Piece of Good 2×4 Wood Position the jack under the engine oil pan, and place a piece of 2×4 between the oil pan and the jack. Then gently raise the jack till the piece [...]
Step 16 – Unbolt the 2 rear bottom transmission mount bolts Tools Needed: 17mm Socket Wrench Use a 17mm socket wrench and unbolt the 2 bottom rear transmission mount bolts. And then unbolt the engine to transmission bolt that is just to the left. . . Step 17 – Unbolt the bottom engine to transmission [...]
Step 14 – Remove the left and right drive shaft from the transmission Tools Needed: Large Flat head screw driver, 17mm Socket Wrench and 17mm Combination Wrench Unbolt the the damper fork bolt using a 17mm socket wrench and a 17mm combination wrench. Check to make sure the steering knuckle is dismounted of the lower [...]
Step 12 – Unscrew the main drive shaft nut on the left and right side of the car Tools Needed: 1-1/4″ Socket, Breaker Bar or Heavy Duty Impact Gun, Propane Torch, Chisel, Hammer, WD-40 Use a chisel and a hammer to undo the locking tabs on the driveshaft nut. Then spray the threads of the nut with WD-40. After the WD-40 [...]
Step 10 – Unbolt the clutch slave cylinder from the transmission Tools Needed: 10mm Socket Wrench and 12mm Socket Wrench Unscrew the two 10mm bolts holding the clutch slave cylinder bracket on the transmission and then move the bracket out of the way and screw the 2 bolts back into the transmission. Then use a 12mm wrench [...]
Step 7 – Remove the starter Tools Needed: 17mm Socket Wrench with long extension and 12mm Combination Wrench Unscrew the positive lead at the back of the starter with a 12mm combination wrench and using your hand pull of the solenoid lead. Next unscrew the 12mm wire harness bracket of the starter and put the bolt back to into it’s spot [...]
Step 5 – Remove the radiator with connecting hoses Tools Needed: 10mm Socket Wrench and Large Pliers Unscrew the 10mm bolt from the front radiator bracket with a 10mm socket wrench. Then use large pliers to undo the 2 hose clamps from the radiator hoses that are on the engine. Then grab the hoses and twist them left to right until you manage to [...]
Posted in Engine Cooling, Honda Civic 1992 to 1995, How To's, Transmission Removal 
Tags: Radiator 
No Comments »Step 3 – Jack up the car and support it on jack stands Tools Needed: Floor Jack and 2 Jack Stands Position the floor jack under the front drivers side jack point as shown in the picture to the left, and jack up the car till the wheels are of the ground about 2-4 inches. Then take a jack stand [...]
Step 1 – Disconnect the battery Tools Needed: 10mm Combination Wrench Loosen the positive and negative battery terminals using a 10mm combination wrench and pull the terminals off the battery posts. . . Step 2 – Remove the air filter box Tools Needed: 10mm Socket Wrench with Extension, Pliers and Phillips Head Screwdriver Loosen the [...]
